Setup and care

Set it up

1. Place the insert in the potThe flat plate rests on the ledge inside the pot. The soil cone hangs down into the tank.
2. Add soil and your plantFill the cone and the plate with regular potting mix, then plant as usual. Press the soil down gently so it touches the cone walls.
3. Fit the fill tubePress the tube's plug into the round hole in the plate. It should stand straight up.
4. Fill the tankPour water into the tube until a little runs out of the overflow hole near the bottom of the pot. That means the tank is full.
5. Water from the top onceGive the soil a normal watering the first time, so the soil in the cone starts out damp and begins carrying water up.

Refill and care

1. Check the tank every few daysEvery plant drinks at its own pace. At first, look often, and you'll learn how long a fill lasts for your plant and room.
2. Refill through the tubeTop up until water runs from the overflow hole again. Don't pour onto the soil.
3. Going away?Fill the tank right before you leave. Try a few days at home first so you know how your plant behaves.
4. Clean it now and thenRinse the pot and insert with warm water and mild soap. Keep them out of the dishwasher, since heat can warp PETG.

Still stuck? Check the FAQ or send me a message.